Flexible rear fender designed specifically for the Ninebot Segway ZT3 Pro. A compact alternative to the long original rear fender.

The shorter design reduces rear overhang and gives your e-scooter a cleaner, sportier appearance. The fender also helps reduce water, dirt and small stones thrown up by the rear wheel.

Made from durable, flexible TPU, it is suitable for everyday use in various riding conditions.

Package contents

✔ 1× rear fender (Flexi)

Key benefits

✔ Compact alternative to the long original rear fender
✔ Clean, sporty appearance with reduced rear overhang
✔ Custom fit for the Ninebot Segway ZT3 Pro
✔ Helps reduce water and dirt spray from the rear wheel
✔ Weather-resistant, impact-resistant and wear-resistant material
✔ Secure four-point mounting
✔ Uses the existing mounting points
✔ No drilling or adhesive required

Installation

✔ Remove the original rear fender with its license plate holder
✔ Position the flexible fender at the existing mounting points
✔ Secure evenly using the original screws
✔ Check that the fender is secure and has sufficient clearance from the tyre
✔ Recheck the screws after the first few rides and tighten if necessary

Compatibility

✔ Segway Ninebot ZT3 Pro

💡 Please note

The shorter design provides less coverage than the long original rear fender. More spray may therefore occur during heavy rain or on very wet roads.

Due to the 3D-printing process, fine layer lines and minor surface irregularities may be visible. These are normal manufacturing characteristics and do not constitute a defect. The actual colour may vary slightly depending on your monitor settings.

The e-scooter, insurance plate and other decorative items shown in the photos are for demonstration purposes only and are not included.

Before using the e-scooter on public roads, check the applicable legal requirements. The user is responsible for correct installation and compliance with applicable rules.