Give your Ninebot ZT3 Pro / Max a distinctive, sporty look. This compact LED tail light combines powerful red LEDs with a flexible TPU housing.

Matching waterproof connectors allow installation without soldering or cutting wires. Simply mount the light and connect it inline with the existing tail light connection.

Material:

✔ Flexible TPU — thermoplastic polyurethane with rubber-like properties

Package Contents:

✔ 1× LED tail light with connection cable and matching waterproof connectors

Key Benefits:

✔ Powerful red LEDs for an intense lighting effect
✔ Individual custom styling for a sporty rear appearance
✔ Designed specifically to fit the Segway Ninebot ZT3 Pro / Max
✔ Plug & Play — no soldering or cutting wires required
✔ Matching connectors for inline connection to the existing tail light wiring
✔ Waterproof connectors protect the electrical connections against rain and moisture
✔ Flexible TPU housing
✔ Compact design with connection cable

Installation:

✔ Switch off the e-scooter
✔ Mount the LED tail light in its intended position
✔ Disconnect the original tail light connector and connect the new LED tail light
✔ Make sure the connector is fully connected
✔ Route the cable securely without tension
✔ Check the mounting and light operation before use

Compatibility:

✔ Segway Ninebot ZT3 Pro / Max

💡 Please Note:

✔ Not an original Segway/Ninebot product.
✔ Approval for use on public roads has not been established.
✔ The waterproof specification applies to the fully connected connectors. No IP rating is specified for the complete tail light.
✔ Fine layer lines or surface textures caused by 3D printing are normal.
✔ Colours may vary slightly depending on lighting and monitor settings.
✔ The e-scooter and other accessories shown are for illustration purposes only and are not included.