Rear fender designed specifically for the Ninebot Segway ZT3 Pro/Max. A compact alternative to the long original rear fender.

The shorter design reduces rear overhang and gives your e-scooter a clean, sporty appearance. The fender helps reduce water, dirt and small stones thrown up by the rear wheel.

Material Options

✔ ABS — durable, rigid plastic that retains its shape
✔ TPU Flex — flexible thermoplastic polyurethane with rubber-like properties that bends under pressure

Select your preferred material when ordering.

Package Contents

✔ 1× rear fender in the selected material

Key Benefits

✔ Compact alternative to the long original rear fender
✔ Clean, sporty appearance with reduced rear overhang
✔ Precision fit for the Ninebot Segway ZT3 Pro/Max
✔ Choice of rigid ABS or flexible TPU
✔ Helps reduce water and dirt spray from the rear wheel
✔ Weather-resistant, impact-resistant and wear-resistant material
✔ Secure four-point mounting
✔ Uses the existing mounting points
✔ No drilling or adhesive required

Installation

✔ Remove the original rear fender with its license plate holder
✔ Position the new fender at the existing mounting points
✔ Secure evenly using the original screws
✔ Check that it is firmly attached and has sufficient clearance from the tyre
✔ Recheck the screws after the first few rides and tighten if necessary

Compatibility

✔ Segway Ninebot ZT3 Pro/Max

Optional License Plate Replica

If you select the license plate replica option, upload a clear photo of your plate when ordering. All letters and numbers must be clearly readable.

We cannot produce a replica of your license plate without an uploaded photo.

💡 Please Note

The shorter design provides less coverage than the long original rear fender. More spray may therefore occur during heavy rain or on very wet roads.

Fine layer lines and minor surface irregularities are normal characteristics of 3D printing and do not constitute defects. The actual colour may vary slightly depending on lighting and monitor settings.

The e-scooter, insurance plate and other accessories shown in the photos are for illustration purposes only and are not included in the standard package. A replica is supplied only when the corresponding option is selected and does not replace an official insurance plate.

Before using the e-scooter on public roads, check the applicable legal requirements. The user is responsible for correct installation and compliance with applicable rules.